SN74HC273QPWRG4Q1

SN74HC273QPWRG4Q1 Overview

20-TSSOP (0.173, 4.40mm Width)is the way it is packaged. It is included in the package Tape & Reel (TR). There is a Non-Invertedoutput configured with it. It is configured with the trigger Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 2V~6V volts. -40°C~125°C TAis the operating temperature. D-Typedescribes this flip flop. FPGAs belonging to the Automotive, AEC-Q100, 74HCseries contain this type of chip. Its output frequency should not exceed 60MHz Hz. The element count is 1 . As a result, it consumes 8μA of quiescent current without being affected by external factors. The number of terminations is 20. The object belongs to the 74HC273 family. It is powered by a voltage of 5V . Its input capacitance is 3pF farads. This D flip flop belongs to the family of HC/UH. This electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. In this device, the clock edge trigger type is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. It is designed with a number of bits of 8. 6Vis the maximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 2V. In view of its reliability, this D flip flop is a good fit for TR. There are 2/6V power supplies attached to it. For high efficiency, the supply voltage should be kept at 5V. The number of input lines is 8.

SN74HC273QPWRG4Q1 Features

Tape & Reel (TR) package
Automotive, AEC-Q100, 74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC273QPWRG4Q1 Applications

There are a lot of Texas Instruments SN74HC273QPWRG4Q1 Flip Flops applications.

• CMOS Process
• Registers
• Automotive
• Guaranteed simultaneous switching noise level
• Dynamic threshold performance
• Balanced 24 mA output drivers
• Memory
• Load Control
• ESD protection
• Shift Registers