SN74HC374DWE4

SN74HC374DWE4 Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. You can find it in the Tubepackage. It is configured with Tri-State, Non-Invertedas an output. JK flip flop uses Positive Edgeas the trigger. Surface Mountmounts this electrical part. A supply voltage of 2V~6V is required for operation. The operating temperature is -40°C~85°C TA. The type of this D latch is D-Type. It is a type of FPGA belonging to the 74HC series. Its output frequency should not exceed 70MHz Hz. The element count is 1 . T flip flop consumes 8μA quiescent energy. There are 20 terminations,It is a member of the 74HC374 family. The D flip flop is powered by a voltage of 5V . There is 3pF input capacitance for this T flip flop. It belongs to the family of electronic devices known as HC/UH. A part of the electronic system is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. It is part of the FF/Latchesbase part number family. There are 8bits in this flip flop. It reaches 6Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 2V. Its superior flexibility is attributed to its use of 8 circuits. It runs on 2/6Vvolts of power. The flip flop has 2embedded ports. Optimal efficiency requires a supply voltage of 5V. The 7.8mA output current allows it to be designed with the greatest amount of flexibility. Currently, there are 3 input lines present.

SN74HC374DWE4 Features

Tube package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC374DWE4 Applications

There are a lot of Texas Instruments SN74HC374DWE4 Flip Flops applications.

• Modulo – n – counter
• Divide a clock signal by 2 or 4
• ESD protection
• ATE
• Bounce elimination switch
• CMOS Process
• Data storage
• Computing
• Digital electronics systems
• Frequency division