SN74HCT273PWR

SN74HCT273PWR Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Cut Tape (CT) package. It is configured with Non-Invertedas an output. It is configured with a trigger that uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. In the operating environment, the temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74HCT series. This D flip flop should not have a frequency greater than 37MHz. D latch consists of 1 elements. It consumes 8μA of quiescent current without being affected by external factors. 20terminations have occurred. D latch belongs to the 74HCT273 family. Power is provided by a 5V supply. There is 3pF input capacitance for this T flip flop. In terms of electronic devices, this device belongs to the HCTfamily of devices. This electronic part is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. A Positive Edgeclock edge trigger is used in this device. There is a FF/Latchesbase part number assigned to the RS flip flops. An electronic part with 8bits has been designed. The superior flexibility is achieved through the use of 8 circuits. Considering the reliability of this T flip flop, it is well suited for TR. A total of 5V power supplies are needed to run it. Optimal efficiency requires a supply voltage of 5V. Its output current of 50mAallows for maximum design flexibility. This input has 3lines in it.

SN74HCT273PWR Features

Cut Tape (CT) package
74HCT series
20 pins
8 Bits
5V power supplies

SN74HCT273PWR Applications

There are a lot of Texas Instruments SN74HCT273PWR Flip Flops applications.

• Pattern generators
• Patented noise
• Guaranteed simultaneous switching noise level
• ATE
• ESD performance
• ESCC
• Reduced system switching noise
• Test & Measurement
• Count Modes
• Differential Individual