SN74HCT574NSR

SN74HCT574NSR Overview

20-SOIC (0.209, 5.30mm Width)is the way it is packaged. D flip flop is included in the Tape & Reel (TR)package. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Surface Mount. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. It is an electronic flip flop with the type D-Type. In terms of FPGAs, it belongs to the 74HCT series. There should be no greater frequency than 40MHzon its output. A total of 1elements are present in it. There have been 20 terminations. Members of the 74HCT574family make up this object. An input voltage of 5Vpowers the D latch. The input capacitance of this JK flip flopis 3pF farads. In this case, the D flip flop belongs to the HCTfamily. It is mounted in the way of Surface Mount. 20pins are included in its design. There is a clock edge trigger type of Positive Edgeon this device. This RS flip flops is a part number FF/Latches. An electronic part with 8bits has been designed. The superior flexibility of this product is achieved by using 8 circuits. In view of its reliability, this D flip flop is a good fit for TR. The D latch runs on a voltage of 5V volts. This D flip flop is equipped with 0 ports. For high efficiency, the supply voltage should be set to 5V. A total of 3input lines have been provided. There is 8μA quiescent current consumption by it.

SN74HCT574NSR Features

Tape & Reel (TR) package
74HCT series
20 pins
8 Bits
5V power supplies

SN74HCT574NSR Applications

There are a lot of Texas Instruments SN74HCT574NSR Flip Flops applications.

• Modulo – n – counter
• Individual Asynchronous Resets
• Storage registers
• Storage Registers
• Consumer
• Matched Rise and Fall
• Test & Measurement
• Convert a momentary switch to a toggle switch
• Frequency Dividers
• Parallel data storage