SN74LS174DR

SN74LS174DR Overview

The package is in the form of 16-SOIC (0.154, 3.90mm Width). The Tape & Reel (TR)package contains it. Currently, the output is configured to use Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. Currently, the operating temperature is 0°C~70°C TA. A flip flop of this type is classified as a D-Type. JK flip flop belongs to the 74LSseries of FPGAs. There should be no greater frequency than 40MHzon its output. In total, there are 1 elements. As a result, it consumes 26mA quiescent current. It has been determined that there have been 16 terminations. The 74LS174 family contains it. Power is provided by a 5V supply. A device of this type belongs to the family of LS. Surface Mount mounts this electronic component. Basically, it is designed with a set of 16 pins. In this device, the clock edge trigger type is Positive Edge. It is part of the FF/Latchesbase part number family. Its superior flexibility is attributed to its use of 7 circuits. In view of its reliability, this D flip flop is a good fit for TR. An electrical current of 5V volts is applied to it. In order to ensure high efficiency, the supply voltage should remain at 5V. Its output current of 8mAallows for maximum design flexibility. There are 2 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply.

SN74LS174DR Features

Tape & Reel (TR) package
74LS series
16 pins
5V power supplies

SN74LS174DR Applications

There are a lot of Texas Instruments SN74LS174DR Flip Flops applications.

• Shift Registers
• Latch
• Shift registers
• Bus hold
• Safety Clamp
• Digital electronics systems
• Buffered Clock
• ESD protection
• Dynamic threshold performance
• Computers