SN74LS374N

SN74LS374N Overview

The flip flop is packaged in 20-DIP (0.300, 7.62mm). D flip flop is embedded in the Tube package. This output is configured with Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. Through Holeis positioned in the way of this electronic part. The supply voltage is set to 4.75V~5.25V. It is at 0°C~70°C TAdegrees Celsius that the system is operating. The type of this D latch is D-Type. This type of FPGA is a part of the 74LS series. A frequency of 50MHzshould be the maximum output frequency. The list contains 1 elements. As a result, it consumes 40mA quiescent current. A total of 20terminations have been recorded. The 74LS374 family contains it. It is powered from a supply voltage of 5V. It is a member of the LSfamily of D flip flop. This electronic part is mounted in the way of Through Hole. It is designed with 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This part is included in FF/Latches. 8bits are used in its design. The system runs on a power supply of 5V watts. A D flip flop with 2embedded ports is available. If high efficiency is desired, the supply voltage should be kept at 5V. As a result of its output current of 24mA, it is very flexible in terms of design. It is designed with 2 output lines. As of now, there are 4input lines. 8 channels are available.

SN74LS374N Features

Tube package
74LS series
20 pins
8 Bits
5V power supplies

SN74LS374N Applications

There are a lot of Texas Instruments SN74LS374N Flip Flops applications.

• Common Clocks
• Matched Rise and Fall
• Pattern generators
• Counters
• ESD protection
• Circuit Design
• Load Control
• Digital electronics systems
• Control circuits
• Dynamic threshold performance