SN74LS74ADE4

SN74LS74ADE4 Overview

The item is packaged in 14-SOIC (0.154, 3.90mm Width)cases. You can find it in the Tubepackage. In the configuration, Differentialis used as the output. In the configuration of the trigger, Positive Edgeis used. There is an electric part mounted in the way of Surface Mount. A supply voltage of 4.75V~5.25V is required for operation. In the operating environment, the temperature is 0°C~70°C TA. D-Typeis the type of this D latch. In this case, it is a type of FPGA belonging to the 74LS series. Its output frequency should not exceed 33MHz Hz. The number of terminations is 14. If you search by 74LS74, you will find similar parts. The D flip flop is powered by a voltage of 5V . An electronic device belonging to the family LScan be found here. It is mounted by the way of Surface Mount. A total of 14pins are provided on this board. Its clock edge trigger type is Positive Edge. The part is included in FF/Latches. The superior flexibility of this circuit is achieved by using 2 circuits. An electrical current of 5V volts is applied to it. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. It offers maximum design flexibility with its output current of 8mA. A total of 3input lines have been provided.

SN74LS74ADE4 Features

Tube package
74LS series
14 pins
5V power supplies

SN74LS74ADE4 Applications

There are a lot of Texas Instruments SN74LS74ADE4 Flip Flops applications.

• Parallel data storage
• Buffer registers
• Buffered Clock
• Functionally equivalent to the MC10/100EL29
• Event Detectors
• Modulo – n – counter
• Guaranteed simultaneous switching noise level
• Patented noise
• Divide a clock signal by 2 or 4
• Control circuits