SN74LV74APWR

SN74LV74APWR Overview

As a result, it is packaged as 14-TSSOP (0.173, 4.40mm Width). As part of the package Cut Tape (CT), it is embedded. T flip flop is configured with an output of Differential. It is configured with a trigger that uses a value of Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~5.5V. It is at -40°C~125°C TAdegrees Celsius that the system is operating. This electronic flip flop is of type D-Type. The FPGA belongs to the 74LV series. It should not exceed 140MHzin terms of its output frequency. The number of terminations is 14. The 74LV74 family contains this object. A voltage of 2.5V is used to power it. Its input capacitance is 2pFfarads. Devices in the LV/LV-A/LVX/Hfamily are electronic devices. There is an electronic part that is mounted in the way of Surface Mount. Basically, it is designed with a set of 14 pins. There is a clock edge trigger type of Positive Edgeon this device. This RS flip flops is a part number FF/Latches. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). Normal operation requires a supply voltage (Vsup) above 2V. Its superior flexibility is attributed to its use of 2 circuits. In light of its reliable performance, this T flip flop is well suited for TR. It runs on 3.3Vvolts of power. Featuring the maximum design flexibility, it has an output current of 12mA . It consumes 20μA of quiescent current without being affected by external factors.

SN74LV74APWR Features

Cut Tape (CT) package
74LV series
14 pins
3.3V power supplies

SN74LV74APWR Applications

There are a lot of Texas Instruments SN74LV74APWR Flip Flops applications.

• Synchronous counter
• Single Down Count-Control Line
• Computing
• Computers
• 2 – Bit synchronous counter
• Guaranteed simultaneous switching noise level
• Power down protection
• Latch
• Patented noise
• Instrumentation