SN74LVC16374ADL

SN74LVC16374ADL Overview

In the form of 48-BSSOP (0.295, 7.50mm Width), it has been packaged. You can find it in the Tubepackage. T flip flop uses Tri-State, Non-Invertedas its output configuration. This trigger is configured to use Positive Edge. Surface Mountis occupied by this electronic component. A voltage of 1.65V~3.6Vis used as the supply voltage. In the operating environment, the temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. The FPGA belongs to the 74LVC series. Its output frequency should not exceed 150MHz Hz. A total of 2elements are contained within it. It consumes 20μA of quiescent current without being affected by external factors. There are 48 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is a member of the 74LVC16374 family. A voltage of 1.8V is used to power it. Its input capacitance is 5pF farads. A device of this type belongs to the family of LVC/LCX/Z. The electronic part is mounted in the way of Surface Mount. This board is designed with 48pins on it. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. An electronic part with 16bits has been designed. It reaches the maximum supply voltage (Vsup) at 3.6V. The system runs on a power supply of 3.3V watts. The flip flop has 2ports embedded within it. The output current of 24mA makes it feature maximum design flexibility. There are no output lines on the JK flip flop.

SN74LVC16374ADL Features

Tube package
74LVC series
48 pins
16 Bits
3.3V power supplies

SN74LVC16374ADL Applications

There are a lot of Texas Instruments SN74LVC16374ADL Flip Flops applications.

• Data Synchronizers
• Memory
• EMI reduction circuitry
• Modulo – n – counter
• Common Clocks
• Matched Rise and Fall
• Bus hold
• Frequency Divider circuits
• Patented noise
• Convert a momentary switch to a toggle switch