SN74LVC1G74DCTR

SN74LVC1G74DCTR Overview

8-LSSOP, 8-MSOP (0.110, 2.80mm Width)is the way it is packaged. There is an embedded version in the package Tape & Reel (TR). T flip flop uses Differentialas its output configuration. This trigger uses the value Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. It operates with a supply voltage of 1.65V~5.5V. In the operating environment, the temperature is -40°C~125°C TA. D-Typedescribes this flip flop. This type of FPGA is a part of the 74LVC series. Its output frequency should not exceed 200MHz. In total, it contains 1 elements. Terminations are 8. The 74LVC1G74 family contains it. A voltage of 3.3V provides power to the D latch. A JK flip flop with a 5pFfarad input capacitance is used here. The electronic device belongs to the LVC/LCX/Zfamily. This electronic part is mounted in the way of Surface Mount. It is designed with 8 pins. There is a clock edge trigger type of Positive Edgeon this device. The part is included in FF/Latches. The flip flop is designed with 1bits. Vsup reaches 5.5V, the maximal supply voltage. Due to its superior flexibility, it uses 1 circuits. Due to its reliability, this T flip flop is well suited for TR. An electrical current of 3.3V volts is applied to it. With an output current of 50mA, it is possible to design the device in any way you want. 10μAquiescent current consumed. In its basic form, it contains 2 gates.

SN74LVC1G74DCTR Features

Tape & Reel (TR) package
74LVC series
8 pins
1 Bits
3.3V power supplies
2 gates

SN74LVC1G74DCTR Applications

There are a lot of Texas Instruments SN74LVC1G74DCTR Flip Flops applications.

• Pattern generators
• 2 – Bit synchronous counter
• Reduced system switching noise
• EMI reduction circuitry
• Guaranteed simultaneous switching noise level
• Load Control
• Clock pulse
• Frequency division
• Asynchronous counter
• Frequency Divider circuits