SN74LVC1G74DQER

SN74LVC1G74DQER Overview

As a result, it is packaged as 8-XFDFN. The package Cut Tape (CT)contains it. It is configured with Differentialas an output. This trigger uses the value Positive Edge. Surface Mountis in the way of this electric part. It operates with a supply voltage of 1.65V~5.5V. In the operating environment, the temperature is -40°C~125°C TA. Logic flip flops of this type are classified as D-Type. In this case, it is a type of FPGA belonging to the 74LVC series. You should not exceed 200MHzin the output frequency of the device. A total of 8 terminations have been made. The 74LVC1G74 family contains it. It is powered by a voltage of 1.8V . A JK flip flop with a 5pFfarad input capacitance is used here. In terms of electronic devices, this device belongs to the LVC/LCX/Zfamily of devices. The electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 8 pins. The clock edge trigger type for this device is Positive Edge. This device is part of the FF/Latchesbase part number family. There are 1bits in its design. The maximal supply voltage (Vsup) reaches 5.5V. Despite its superior flexibility, it relies on 2 circuits to achieve it. As a result of its reliability, this D flip flop is ideally suited for TR. A power supply of 3.3Vis required to operate it. It is designed with 1 output lines. There is a consumption of 10μAof quiescent current from it.

SN74LVC1G74DQER Features

Cut Tape (CT) package
74LVC series
8 pins
1 Bits
3.3V power supplies

SN74LVC1G74DQER Applications

There are a lot of Texas Instruments SN74LVC1G74DQER Flip Flops applications.

• 2 – Bit synchronous counter
• Convert a momentary switch to a toggle switch
• Matched Rise and Fall
• Divide a clock signal by 2 or 4
• ESD performance
• Buffer registers
• Test & Measurement
• ESD protection
• Consumer
• Count Modes