SN74LVC1G79YZPR

SN74LVC1G79YZPR Overview

As a result, it is packaged as 5-XFBGA, DSBGA. D flip flop is included in the Tape & Reel (TR)package. Non-Invertedis the output configured for it. This trigger uses the value Positive Edge. Surface Mountmounts this electrical part. The JK flip flop operates at a voltage of 1.65V~5.5V. Temperature is set to -40°C~85°C TA. A flip flop of this type is classified as a D-Type. The FPGA belongs to the 74LVC series. It should not exceed 160MHzin terms of its output frequency. Terminations are 5. JK flip flop belongs to 74LVC1G79 family. An input voltage of 1.8Vpowers the D latch. JK flip flop input capacitance is 4pF farads. It belongs to the family of electronic devices known as LVC/LCX/Z. Electronic part Surface Mountis mounted in the way. As you can see from the design, it has pins with 5. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. 1bits are used in its design. The superior flexibility of this product is achieved by using 1 circuits. This D flip flop is well suited for TR based on its reliable performance. The system runs on a power supply of 3.3V watts. As a result of its output current of 32mA, it is very flexible in terms of design. This D latch consumes 10μA quiescent current at all.

SN74LVC1G79YZPR Features

Tape & Reel (TR) package
74LVC series
5 pins
1 Bits
3.3V power supplies

SN74LVC1G79YZPR Applications

There are a lot of Texas Instruments SN74LVC1G79YZPR Flip Flops applications.

• Dynamic threshold performance
• 2 – Bit synchronous counter
• Data Synchronizers
• Control circuits
• Matched Rise and Fall
• Balanced Propagation Delays
• ATE
• Frequency Divider circuits
• ESD protection
• Digital electronics systems