SN74LVC2G74DCUTG4

SN74LVC2G74DCUTG4 Overview

The flip flop is packaged in a case of 8-VFSOP (0.091, 2.30mm Width). It is contained within the Tape & Reel (TR)package. T flip flop is configured with an output of Differential. This trigger uses the value Positive Edge. Surface Mountis positioned in the way of this electronic part. A voltage of 1.65V~5.5Vis required for its operation. Temperature is set to -40°C~125°C TA. The type of this D latch is D-Type. This type of FPGA is a part of the 74LVC series. Its output frequency should not exceed 140MHz Hz. Despite external influences, it consumes 10μAof quiescent current. The number of terminations is 8. Members of the 74LVC2G74family make up this object. A voltage of 1.8V is used as the power supply for this D latch. There is 5pF input capacitance for this T flip flop. This D flip flop belongs to the family of LVC/LCX/Z. Electronic part Surface Mountis mounted in the way. With its 8pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This RS flip flops is a part number FF/Latches. There are 1bits in its design. 5.5Vis the maximum supply voltage (Vsup). In order to achieve its superior flexibility, 1 circuits are used. In light of its reliable performance, this T flip flop is well suited for TR. The D latch operates on 3.3V volts. There are 2 gates in its basic building block.

SN74LVC2G74DCUTG4 Features

Tape & Reel (TR) package
74LVC series
8 pins
1 Bits
3.3V power supplies
2 gates

SN74LVC2G74DCUTG4 Applications

There are a lot of Texas Instruments SN74LVC2G74DCUTG4 Flip Flops applications.

• Synchronous counter
• Safety Clamp
• Convert a momentary switch to a toggle switch
• ESD protection
• Single Up Count-Control Line
• Buffer registers
• 2 – Bit synchronous counter
• Frequency Divider circuits
• Individual Asynchronous Resets
• ESD performance