SN74LVC2G80DCURE4

SN74LVC2G80DCURE4 Overview

It is packaged in the way of 8-VFSOP (0.091, 2.30mm Width). You can find it in the Tape & Reel (TR)package. T flip flop uses Invertedas the output. This trigger uses the value Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates at 1.65V~5.5Vvolts. Temperature is set to -40°C~125°C TA. D-Typedescribes this flip flop. JK flip flop belongs to the 74LVCseries of FPGAs. There should be no greater frequency than 160MHzon its output. As a result, it consumes 5μA quiescent current. In 8terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. You can search similar parts based on 74LVC2G80. Power is provided by a 1.8V supply. The input capacitance of this T flip flop is 3.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This D flip flop belongs to the family of LVC/LCX/Z. It is mounted by the way of Surface Mount. The 8pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. It is included in FF/Latches. As soon as Vsup reaches 5.5V, the maximum supply voltage is reached. In order to achieve its superior flexibility, 2 circuits are used. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. The D latch runs on a voltage of 3.3V volts. There are 1 output lines on it.

SN74LVC2G80DCURE4 Features

Tape & Reel (TR) package
74LVC series
8 pins
3.3V power supplies

SN74LVC2G80DCURE4 Applications

There are a lot of Texas Instruments SN74LVC2G80DCURE4 Flip Flops applications.

• Storage Registers
• Modulo – n – counter
• Circuit Design
• Counters
• High Performance Logic for test systems
• Balanced Propagation Delays
• Buffer registers
• Pattern generators
• Matched Rise and Fall
• 2 – Bit synchronous counter