SN74LVC574ADGVR

SN74LVC574ADGVR Overview

In the form of 20-TFSOP (0.173, 4.40mm Width), it has been packaged. You can find it in the Cut Tape (CT)package. Currently, the output is configured to use Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. There is an electric part mounted in the way of Surface Mount. A 1.65V~3.6Vsupply voltage is required for it to operate. A temperature of -40°C~125°C TAis considered to be the operating temperature. It belongs to the type D-Typeof flip flops. This type of FPGA is a part of the 74LVC series. Its output frequency should not exceed 150MHz. The element count is 1 . Despite external influences, it consumes 10μAof quiescent current. Terminations are 20. JK flip flop belongs to 74LVC574 family. Power is provided by a 1.8V supply. A 4pFfarad input capacitance is provided by this T flip flop. A device of this type belongs to the family of LVC/LCX/Z. A part of the electronic system is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. This device's clock edge trigger type is Positive Edge. This RS flip flops is a part number FF/Latches. This flip flop is designed with 8 Bits. Due to its superior flexibility, it uses 8 circuits. This D flip flop is well suited for TR based on its reliable performance. The D flip flop has no ports embedded. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. This input has 3lines in it. There is 1.5μA quiescent current consumption by it.

SN74LVC574ADGVR Features

Cut Tape (CT) package
74LVC series
20 pins
8 Bits

SN74LVC574ADGVR Applications

There are a lot of Texas Instruments SN74LVC574ADGVR Flip Flops applications.

• Count Modes
• Memory
• Computers
• Frequency Dividers
• Frequency Divider circuits
• Guaranteed simultaneous switching noise level
• Data Synchronizers
• Power down protection
• Registers
• Asynchronous counter