SN74LVC574APWRE4

SN74LVC574APWRE4 Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). It is contained within the Tape & Reel (TR)package. T flip flop uses Tri-State, Non-Invertedas its output configuration. There is a trigger configured with Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 1.65V~3.6V volts. In this case, the operating temperature is -40°C~125°C TA. It is an electronic flip flop with the type D-Type. In this case, it is a type of FPGA belonging to the 74LVC series. Its output frequency should not exceed 150MHz Hz. The element count is 1 . This process consumes 10μA quiescents. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. JK flip flop belongs to 74LVC574 family. It is powered from a supply voltage of 1.8V. A 4pFfarad input capacitance is provided by this T flip flop. In this case, the D flip flop belongs to the LVC/LCX/Zfamily. A part of the electronic system is mounted in the way of Surface Mount. There are 20pins on it. It has a clock edge trigger type of Positive Edge. The part you are looking for is included in Bus Driver/Transceiver. An electronic part designed with 8bits is used in this application. The superior flexibility of this product is achieved by using 8 circuits. A reliable performance of this D flip flop makes it well suited for use in TR. A total of 2ports are embedded in the D flip flop. Its output current of 24mAallows for maximum design flexibility. This input has 3lines in it.

SN74LVC574APWRE4 Features

Tape & Reel (TR) package
74LVC series
20 pins
8 Bits

SN74LVC574APWRE4 Applications

There are a lot of Texas Instruments SN74LVC574APWRE4 Flip Flops applications.

• EMI reduction circuitry
• Set-reset capability
• Shift registers
• Safety Clamp
• Pattern generators
• Test & Measurement
• Synchronous counter
• CMOS Process
• Buffered Clock
• Single Down Count-Control Line