SN74LVC821ADWR

SN74LVC821ADWR Overview

As a result, it is packaged as 24-SOIC (0.295, 7.50mm Width). It is contained within the Cut Tape (CT)package. T flip flop is configured with an output of Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. This electronic part is mounted in the way of Surface Mount. With a supply voltage of 1.65V~3.6V volts, it operates. -40°C~85°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. It is a type of FPGA belonging to the 74LVC series. You should not exceed 150MHzin the output frequency of the device. The element count is 1 . There is 10μA quiescent consumption. The number of terminations is 24. The 74LVC821 family contains it. A voltage of 1.8V provides power to the D latch. Its input capacitance is 5pF farads. A device of this type belongs to the family of LVC/LCX/Z. Electronic part Surface Mountis mounted in the way. There are 24pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is included in FF/Latches. Due to its superior flexibility, it uses 8 circuits. As a result of its reliable performance, this T flip flop is suitable for TR. The flip flop contains 2ports. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. It has 3 output lines to operate.

SN74LVC821ADWR Features

Cut Tape (CT) package
74LVC series
24 pins

SN74LVC821ADWR Applications

There are a lot of Texas Instruments SN74LVC821ADWR Flip Flops applications.

• Balanced Propagation Delays
• Shift registers
• ATE
• Power down protection
• Storage Registers
• Pattern generators
• Circuit Design
• Parallel data storage
• Digital electronics systems
• Dynamic threshold performance