TPS40091RHDR

TPS40091RHDR Overview

Capsuled in the 28-VFQFN Exposed Pad package, the switching controller suits most application needs. The dc motor controller is adquate to generate for 4 outputs. Packaged in solid enclosures, this pmic has a Tape & Reel (TR) rating. The program can handle PWM Signal dc switching's outputs (s). dc controls with 4.5V~15V voltage are supplied and operated. Suitable for work in a -40°C~85°C TA dc switcher. A switching controller such as this can switch at a value of 100kHz~1.2MHz . It is suitable for general dc dc regulator when it is set to Surface Mount. DCDC regulator is controlled efficiently by Current Limit, Enable, Frequency Control, Power Good, Soft Start. The switch converters are connected to an analog IC with a SWITCHING CONTROLLER output. There are a QUAD terminal on the switching converters. The 28 terminations can be used for a wide range of dc switching. To name a few of the control techniques these dc dc converter ics adapt, it includes PULSE WIDTH MODULATION. The nominal DC switcher's voltage input is 12V. You can find other relevant dc to dc converter ics by searching "TPS40091". In total, switching converter has 28 pins. Specifically, switching converter falls under the Switching Regulator or Controllers category. Based on the test statistics, DC regulator outputs voltage 3.3V. normally, the dc dc regulator's output current is 120A, which you should keep in mind when starting a project. DC regulator's maximum frequency is 1MHz. DC to DC voltage regulator has the value of IT CAN ALSO OPERATE WITH CURRENT MODE to better satisfy the requirement. If the user wishes to run the voltage regulator dc to dc in a circuit safely and reliably, they should apply 15V. In dormant mode, 4mA is used. Since the dc switcher's maximum input voltage is 15V, the voltage must be regulated accordingly. The supply voltage must be 4.5V. An output current greater than 120A cannot be provided by the dc switcher. Datasheets indicate that the switching converter can output 3.3V volts at its maximum. Its lowest voltage output is not less than 700mV.

TPS40091RHDR Features

PWM Signal Outputs
Switching Frequency: 100kHz~1.2MHz
Current Limit, Enable, Frequency Control, Power Good, Soft Start
PULSE WIDTH MODULATION
IT CAN ALSO OPERATE WITH CURRENT MODE

TPS40091RHDR Applications

There are a lot of Texas Instruments TPS40091RHDR DC to DC converter applications.

• Lathes
• Radio equipment
• Series voltage regulation circuits
• Various precision measuring instruments
• Electrical distribution systems
• Communication system
• Planers
• CNC system
• Computer-related products
• Photovoltaic power