TPS40195RGYT

TPS40195RGYT Overview

It comes in a 16-VFQFN Exposed Pad package, so switching controller can be used for most applications. There is enough capacity in the dc motor controller to generate the output for the 1 input. Tape & Reel (TR) is the solid enclosure in which PMIC is packaged. Transistor Driver dc switching's outputs (s) can be handled by it. The supply and operating voltage of the dc control are 4.5V~20V. Workable in an dc switcher where -40°C~125°C TJ is the -40°C~125°C TJrm. The switching controller is capable of switching at the 100kHz~600kHz position. It is suitable for general dc dc regulator when it is set to Surface Mount. The dcdc regulator features Current Limit, Enable, Frequency Control, Power Good, Soft Start for efficient switching control. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. Terminal (s) of the switching converters are designed at the QUAD position. A variety of 16 terminations are available in dc switching. PULSE WIDTH MODULATION is an example of one of the control techniques these dc dc converter ics adapt. DC switcher's input voltageis set to 12V. A search for "TPS40195" will reveal other relevant dc to dc converter ics. In total, switching converter has 16 pins. As determined by the test statistics, the output voltage of DC regulator is 17V. If you are starting a new project, you should note the dc dc regulator's typical output current is 20A. There is a maximum frequency of 580kHz on this dc regulators. It is suggested that users apply 20V to the voltage regulator dc to dc in order to run it safely and reliably in a circuit. In a dormant state, the dc switching uses 4mA. The maximum input voltage of dc switcher is 20V, so users should limit their voltage accordingly. The supply voltage must be 4.5V. Input current cannot exceed 20A with this dc switcher. The switching converter can output 17V volts at its utmost, according to the datasheet. voltage controllers with a minimum voltage output of 591mV cannot operate.

TPS40195RGYT Features

Transistor Driver Outputs
Switching Frequency: 100kHz~600kHz
Current Limit, Enable, Frequency Control, Power Good, Soft Start
PULSE WIDTH MODULATION

TPS40195RGYT Applications

There are a lot of Texas Instruments TPS40195RGYT DC to DC converter applications.

• Wind power
• Hydraulic presses
• Printing
• Post equipment
• CNC system
• Scientific research
• Shearing machines
• Handheld GPS
• Precision electronic equipment
• Linear guide